Management Kit is a security and remote management tool.The security part consists of the login program and hiding of the program.
Remote management consists of creating your own commands from small basic commands under the plus icon in the table. Get a brief hint in the status bar by keeping the cursor over subcommands when choosing a set from them. With the navigator under the command table you can add, delete, navigate commands. If you uncheck the Enable command flag this command will become unexecutable.You may write the message with your subject known only to you and a command bulk (command names) in the body. Each command has to be separated by commas. They will execute command by command. The 'Listen to e-mail and SMS commands > Enable E-mail' option must be on to check your mailbox for the specified subject. The 'Listen to e-mail and SMS commands > Enable SMS' option must be on to check new SMS messages for the specified password (the SMS password should be at the first position of the command list in the SMS message).
The program doesn't touch other messages. Command messages will be deleted after execution.
Listen to e-mail and SMS commands
Select the ways of receiving commands: by e-mail and/or sms and/or http.
Periodically check your email inbox. See Incoming Mail Server(POP)
Enter the Subject of e-mail command message. Only messages with the same subject will be executed.
Management Kit cycle.
Management Kit cycle time interval.
Management Kit cycle time interval units.
You will receive a status e-mail message.
Enter recipients of your message. Use a comma to separate multiple addresses on the same line.
Enter the subject of e-mail status message.
Check for new SMS messages regularly. See Mobile Phone > SMS
options as well.
Enter the password of a command SMS message. Only SMS messages with the same password at the first position of the command list will be executed.
You will receive an SMS message about the status of the program. Do not rely only on SMS because the mobile service provider can delay sending your message from several minutes to several days.
Enter the recipients of your SMS messages. Use a comma to separate multiple addresses on the same line.
Enter the subject of the status SMS message.
Allows the program to accept commands via the enabled 'HTTP Server' feature. See also the HTTP Server
You can also enable the 'HTTP Server > Authentication' option to protect the program. In this case you should specify the Name and Password command parameters.
1. Enable the 'Management Kit > Listen to' feature.
2. Enable the 'Management Kit > Listen to > Enable HTTP' option.
3. Enable the 'HTTP Server > Enable' option.
Please take a look at the 'Program Files\Willing Webcam\Web Pages\HTTP Server\Commands\index.html' web page. You can use this remote control panel both from the local hard disk and from any website.
You can also use this page as a template for creating your own web page (for example, for sending the tilt, pan, zoom commands).
Processes commands according to the specified time. You can set time for two command lines.
Each of them can be run every day or on a certain day and time. Use a comma to separate multiple
commands on one line. Please see the Commands page below for the option table.
Enable the command execution.
Time of the command execution.
Automatically changes the 'To' time value every day according to your geographic location.
See also the 'Preferences > Location' options. You have to specify your precise coordinates
(degrees) taken from a GPS receiver or a map in the 'Preferences > Location > Longitude' and 'Latitude' fields
Longitude is positive to the east from Greenwich. Latitude is positive in
the Northern hemisphere. The time zone is positive to the east from Greenwich.
See the Commands page. Use a comma to separate multiple commands on one line.
The program executes the commands every day at the specified time.
The program executes the commands on the specified date and time.
An option to hide the program from viewing by others.
Restore Hot Key
Restore Hot Key after stealth hiding. Press any key to set 'Ctrl,Alt,Shift + key' combination and then minimize the program.
Enable program login password.
Enter program login password.
Membership in the Administrator's group is required for program login.